Board logo

标题: staad beava ( 2004)不能用,求救! [打印本页]

作者: banach    时间: 2005-11-5 09:39     标题: staad beava ( 2004)不能用,求救!

The latest model I am inputing gives an error message when I try to run the influence surface generator.

"The Influence surrface results are missing or ivalid."

When I run the influence surface generator it gets to the point where it is calculating joint displacements. It never finishes and then displays the message above.




欢迎光临 中华钢结构论坛 China Structure Forum (http://bbs.okok.org/) Powered by Discuz! 5.0.0