Board logo

标题: "JTORIG xOrigin yOrigin zOrigin"这命令咋用啊 [打印本页]

作者: CuteSer    时间: 2009-6-25 17:37     标题: "JTORIG xOrigin yOrigin zOrigin"这命令咋用啊

“5.11 Joint  Coordinates  Specification”
提到“To create multiple offset structural parts, enter additional JOINT COORDINATES commands, each one followed by its JTORIG command. An example showing the use of this command is provided later in this section.”

咋也没找到这个所谓的“ An example”啊?




欢迎光临 中华钢结构论坛 China Structure Forum (http://bbs.okok.org/) Powered by Discuz! 5.0.0